the links between the chain commands are so unstable
已回覆do we know why the links between the chain commands are so unstable? in the first run everything was fine in one flow but some links failed in other flows, we fixed those failed links and the 2nd run failed again as the fixed links work now but the good links in the previous run failed, and the circle goes on and on, at the end, we were never able to have all links that work in one run. see screenshot below, the "FR-SA Group" commands were not run because the link above them failed, once we deleted them and created new ones, they worked in next run but the good links above them failed again. Any idea how to prevent this?
-
Hi Jiang. For my understanding, by "failed links" do you mean that commands didn't run when you expected them to run? Below are a couple areas to begin troubleshooting.
Double check any configured skip conditions and all input values in 'FR-SA Group SAM2' command. If this command has a skip condition configured, the conditions may have been met to cause the skip. Otherwise, verify all input values and update any as needed.
Both 'FR-SA Group SAM3' and 'FR-SA Group SAM4' commands have red circles around them in your screenshot which indicate an error. Check LOGS to see if any additional information is provided.
0請登入寫評論。
評論
1 條評論